Glen-L 11 Bill of Materials
The following list of materials gives an approximate listing for the lumber
required for the construction of the GLEN-L 11. The strip planking and similar
type materials can only be approximated as noted in the instructions. By
judicious cutting, the sheer and keel can also be ripped from clear areas in
the planking stock. Before ordering any material, check to the instructions for
the numerous options and suggestions for use of materials. All solid lumber
listed as pine can be standard knotty pine shelving lumber, either Ponderosa or
Sugar Pine. Spruce refers to the Sitka vertical grain variety. All lumber
listed as 1" is standard four quarters lumberyard stock that will usually
finish 3/4" to 13/16" in thickness. All lengths allow for cutting to
size. All widths except 12" stock are net. All plywood (PW) to remain in
the hull structure must be an exterior grade. Douglas-fir (DF) of AB grade is
satisfactory in all cases. Forms that are not a part of the hull may be of any
grade of plywood.
ITEM |
MATERIAL |
NO. PCs. |
SIZE |
Stem, transom-Rudder
Forms 1-4 & 5 &
Centerboard |
EXT DF PW-AB |
1 |
5/8" x 4' x 8' |
Forms 2 & 3 |
DF PW |
1 |
1/2" x 4' x 5' |
Centerboard case,
inner laminated sheer |
EXT DF PW-AB |
1 |
1/4" x 4' x 8' |
Keel |
Pine or fir |
1 |
1" x 4" x 10' |
Planking, Seat, cleats,
center- board case |
Pine |
4 |
1" x 12" x 16' |
Outer sheer |
Pine |
2 |
1" x 1-1/2" x 14' |
Seat |
Mahog |
1 |
1" x 12" |
Mast |
Spruce |
2 |
1-1/4" x 3" x 18' |
Boom |
Spruce |
1 |
1-1/4" Net x 2" x 8' |
FASTENINGS:
- 1 lb - 1" #18 Brads for edge nailing strip Pine planking.
FIBERGLASS MATERIALS:
- 38" 1 oz. mat - 1 yd.
- 38" 7 oz. cloth - 38 yds.
- Epoxy or polyester resin - 8 gals.
- Epoxy option only: Substitute 2 yards of 38" 7 oz. cloth for above
mat
- Polyester option only: Catalyst for above
- Polyester option only: Surfacing agent for 3 gallons (or substitute 3 gals.
of finish resin
|
Return
|