Fairing boards |
|
1. 4mm plywood left over from the Rob-Roy cutout, and some new 60, 80, 100 and 120 grit sanding belts cut at the seam. | |
2. Plywood pieces cut to 3" x 12" and 3" x 18". Handles made from Alder 1 1/2" sq. x 2" long blocks and a roll of 1/8" cork. (Inspector Stevie taking it all in.) | |
3. All the boards glued up with handles sanded and rounded for comfy grip. | |
4. Cork is cut to size and waiting to be glued on. It will be glued on with 3M, Super 77 spray contact adhesive. Spraying both pieces will make it a fairly permanent bond. | |
5. Sanding belts cut to fit and glued on again with 3M spray adhesive, but this time I only sprayed the paper back of the belts. That will allow them to be removed and replaced later if and when worn out ( or when I get sloppy and drip epoxy resin on one and totally ruin it before getting to use it). :( Hey, "Stuff Happens" :) |