Re: installing throttle cables to motor on picklefork


[ Boatbuilder Connection ]


Posted by steve roffey on October 28, 2003 at 19:05:18:

In Reply to: installing throttle cables to motor on picklefork posted by john on October 23, 2003 at 11:43:08:

From what I remember, Chrysler conrols should be the same as OMC. If that is so you need 2 U shaped clips that screw to the side of the motor. The cable then hooks into the clip and then snaps onto the throttle arm, behind where the tiller handle was.


[ Boatbuilder Connection ]