Posted by David on September 24, 2002 at 12:27:43:
In Reply to: Re: Bandido conversion to center console posted by TIMMY on September 23, 2002 at 18:12:40:
: : Has anyone considered converting the bandido to center console? If so, could it also be changed to a conventional single diesel straight shaft set up centrally located, offseting the weight by moving fuel tanks aft?
: HI,
: I am not familiar with the design. But you seem to have the right idea.
: I have found that most anything is possible if you think it through.
: Just don't overload your boat (diesels are heavy)and be careful to keep weight on stern, or when you get on following sea your boat could become a submarine when bow hits the wave ahead.Or could dig in and turn sharpely and try to roll over.
: Good luck with your project.
Thanks for the input Timmy. I've ordered the study plans for this design. My main concern is the bulkhead layout and (or) supports. I think getting the weight balance correct can be done carefully. The engine weight should not be a problem. I have a Cummins 6BT rated at 350H.P. and only weights 950 pounds.
I saw in one of your earlier responses, that you suggested using yellow treated pine for framing and bc ply for sheating. Do you ever experience delam problems with the fiberglass? Just curious