Re: How to get natural wood finish w/ fiberglass?


[ Boatbuilder Connection ]


Posted by Mark Bronkalla on December 19, 2002 at 20:40:07:

In Reply to: Re: How to get natural wood finish w/ fiberglass? posted by JimB on December 19, 2002 at 19:01:32:

For mine, I used 4 oz "deck cloth" on the top and 6 oz on the sides. The 4 oz is very nearly invisible except at a low angle in a few spots where it has the faintest "shimmer" in the finish. 4 oz cloth is a bit hard to find but Glen-L has it.

The wood really "lights up" under the epoxy. It is very similar in depth to an oil and varnish finish.

The cloth provides a lot of dent and abrasion protection. In 3 seasons of hard use there is one small delamination spot to repair (due to being bashed by a pontoon boat), but the glass has held and remained water tight. If it had been wood and varnish, there would have been a gouge and bare wood.




Follow Ups:


[ Boatbuilder Connection ]