Posted by John Ruestow on January 13, 1999 at 11:51:40:
In Reply to: Cast Keel posted by Jim Benge on December 07, 1998 at 14:28:06:
: I am building the Glen-L Reliant and am ready to have the ballast keel cast. Does any body know a foundry in Texas or neighboring state that could handle a job like this? It is roughly 11' long x 38 " tall and should weigh when complete 12,400#. The pattern is cut and ready to be shipped to a foundry if I can find an affordable shop to do it. If not, I may have to pour it with lead myself, but I would rather use cast iron.
Reply:
There is a foundry in Fort Smith, Arkansas that might be able to assist.
Didion Mid-South Corporation
4721 S. Zero St.
Fort Smith, AR 72908
501-646-1686
: Thanks,
:
: Jim Benge